Homeowner Guide
Hurricane Season AC Prep for Bradenton Homes
Hurricane season AC prep is easy to overlook while you are stocking water and putting up shutters. A few steps before a storm, and a careful restart after it, can protect equipment that is expensive to replace and hard to get serviced when the whole region needs help at once.
- Before the season
- When a storm is coming
- After the storm passes
Before the season starts
The Atlantic hurricane season runs from June 1 through November 30, and it overlaps with the hottest months of the year. The best time to prepare your air conditioner is before you need it in a hurry.
- Get your spring tune-up done. A system with a weak capacitor or a partly clogged drain is more likely to fail after a storm or a power surge. Regular AC maintenance catches those first.
- Check the outdoor unit’s tie-downs. In Florida, outdoor units are generally required to be secured to their pad or stand. Look for straps or brackets and make sure they are intact and not badly rusted. If they are missing or loose, ask about securing the unit properly.
- Clear the area around the unit. Trim back branches and remove loose items, such as planters, decorations and yard tools, that could become projectiles.
- Know where your disconnect and breaker are. The outdoor disconnect is usually in a box on the wall near the unit. The breakers are in your main panel. Label them now so you are not guessing in the dark.
- Take photos. Photograph the outdoor unit, the data plate and the air handler. Those records help with insurance and with any repair later.
- Consider surge protection. Storms and the power fluctuations that follow are hard on electronics and control boards. Ask a qualified professional about surge protection options for your home and HVAC system.
When a storm is on the way
Once a storm is forecast for your area and you are preparing your home:
- 1
Pre-cool and dry the house
Running the AC a little cooler than usual before the storm can buy some comfort if power goes out, and it lowers indoor humidity.
- 2
Turn the system off before the worst weather
When high winds or flooding are expected, or when power starts flickering, turn the thermostat off and switch off the AC breaker or outdoor disconnect. This helps protect the equipment from surges and from running with debris or water around it.
- 3
Do not run it covered
If you put a cover over the outdoor unit to keep out debris, never run the system with the cover on. Remove it before turning the system back on.
- 4
Secure loose items one more time
Do a last walk around the unit for anything that could blow into it.
After the storm: check before you restart
The urge to get the AC running again is strong, especially in September heat. Take a few minutes first. Starting a damaged or flooded system can turn a manageable repair into a replacement, or create an electrical hazard.
- Look at the outdoor unit from a safe distance. Is it still level and attached to its pad or stand? Are the refrigerant lines intact? Is there debris inside the fan grille or packed against the coil?
- Check for flooding. If floodwater reached the outdoor unit, the air handler or the electrical components, do not turn the system on. Floodwater, especially salt water, can damage electrical parts and controls in ways that are not visible. Have it inspected first.
- Clear light debris carefully. With the power off at the disconnect and breaker, you can remove leaves and small branches from around the unit. Do not reach inside the fan area.
- Wait for stable power. After an outage, it is common for power to flicker as the grid is restored. Give it a little time before restarting, then turn the breaker back on, wait a few minutes and set the thermostat to Cool.
- Watch and listen. If the outdoor unit hums without the fan spinning, a breaker trips, you smell burning, or the air stays warm, turn the system off and call for service.
Flooded equipment needs an inspection first
If water reached your outdoor unit, air handler or their electrical connections, leave the system off and call (941) 919-3792. Do not try to dry it out and restart it yourself.
Generators and your air conditioner
Many portable generators cannot run a central air conditioner, and connecting a generator to your home wiring the wrong way can be dangerous for you and for utility workers. If you want backup power for cooling, talk with a licensed electrician about sizing and a safe transfer setup. Always run portable generators outdoors, well away from doors, windows and vents.
Common post-storm AC problems
The problems we most often see after storms are surge-damaged capacitors, contactors and control boards, tripped breakers, bent coil fins from debris, damaged refrigerant line insulation, and drain lines clogged by debris or shifted during the storm. Some are simple repairs. Others take longer, especially when parts are in demand across the region. If your system will not run, our AC not cooling guide walks through what to check, and our emergency AC repair page covers staying safe and cool while you wait.
Get your system ready before the next storm
Call (941) 919-3792 or schedule a tune-up. We will check the electrical parts, drain and outdoor unit so it is in good shape going into storm season.
Ready to get comfortable again?
Talk to a local HVAC pro who will diagnose the problem, explain your options and give you a straight answer.